Servo Drive

Servo ISA-7 Series

■ High-Performance Position/Speed/Torque control and Mixed control mode.

■  Support 200W ~ 2kW motor / drive.

■ Within 1kW models can be used a single phase  220V power supply.

■ Separated from the main power and control power supply, improve the stability of the driver.

■ More than 400W models built-in regenerative resistor, reducing wiring and costs.

■ Parameter Group management, Easy to use and tuning.

■ Notch Filter and Low-Frequency vibration suppression support.

■  Max. 4Mpps (Line receiver).  Implements high precision positioning control.

■ Support the high resolution 17-bit incremental encoder. (20bit incremental encoder is expected to 2017-Q1 Release).

■ Provide ISA-Soft utility software, can be edit, parameters, monitor the status and oscilloscopes.

Speed control range
Analog speed command 1:2000, internal speed command 1:5000
Frequency response characteristic
550Hz maximum
Command source
External analog signal/Internal parameters
Smooth strategy
Low-pass and S-curve filter
Analog speed command input
0 to ±10 VDC/ rated speed (Speed at 10V is changeable with parameter) (input impedance: 10kΩ to 12kΩ)
Speed fluctuation rate
±0.01% maximum (load fluctuation: 0 to 100%), 0% (power fluctuation: ±10%)
± 0.2% maximum (ambient temperature: 25°C ±10°C) only when using analog speed command
Torque limit
Set by parameters or external analog input (0 to +10 VDC/maximum torque)
Command source
External analog signal
Smooth strategy
Low-pass filter
Analog torque command input
0 to ±8VDC/maximum torque (input impedance: 10kΩ to 12kΩ)
Speed limit
Set by parameters or external analog input (0 to ±10VDC/rated speed)
Servo functions
Auto-tuning, auto notch filter, auto vibration suppression control
Compliance to standards
IEC/EN 61800-5-1
Ambience
Indoors (no direct sunlight); no corrosive gas, inflammable gas, oil mist or dust
No data!
DocumentISA-7 User Manual
Size9 MBytes2017-12-28 Update
Type